Gary Tyne
CONNECT Conversations
Myths and Pitfalls of Planning & Scheduling – CONNECT Conversations
We’ll be reviewing the various pitfalls and myths associated with effectively installing a CMMS. For example, if the total number of defects coming into the process on a daily basis overwhelm your ability to effectively plan and schedule, the system will fail. We’ll review the importance of defect elimination, especially upstream of maintenance in operations and design, the importance of have a proper PM program, a proper condition monitoring program, the importance of integrating the production plan and the maintenance plan into a single plan, among other issues...
- Ron Moore
- RELIABILITY CONNECT
Webinars
Myths and Pitfalls of Reliability – CONNECT Conversations
This podcast will provide a cautionary tale, and suggest some additional work that must be done to assure a reliable operation, especially in designing, buying, storing, starting up, and operating for reliability, which is where most of the defects originate. These areas must be managed for reliability and defect elimination in collaboration with maintenance in order to have reliability, and operational excellence.
- Ron Moore
- RELIABILITY CONNECT
CONNECT Conversations
Expectations, Execution and Engagement – Essential – CONNECT Conversations
It’s been our experience that the lowest standard you set is the highest standard you can expect. As such, your expectations (standards) should be fairly high, but achievable. It does little good to set expectations too low – too easy, or too high – assuring failure....
- Ron Moore
- RELIABILITY CONNECT
CONNECT Conversations
Maintenance Costs as a % of ARV – Is It Useful? – CONNECT Conversations
Maintenance Cost as a Percent of Asset Replacement Value is often used as a measure to determine the effectiveness of the maintenance function. But, is it? In this podcast we’ll discuss the various means of calculating its value, and by implication, some of its downsides, along with a range of its value for various operations and potential reasons for that variation.
- Ron Moore
- RELIABILITY CONNECT
CONNECT Conversations
Why Do We Measure OEE? – CONNECT Conversations
Manufacturing and other industrial operations are typically familiar with measuring OEE, but there is often confusion about how to measure, where to measure, the rate to use and other issues related to its measurement...
- Ron Moore
- RELIABILITY CONNECT
CONNECT Conversations
Reliability: A New Definition with Special Guest Gary Tyne – CONNECT Conversations
SMRP, SAE, and perhaps other organizations have a definition for reliability. Generally speaking, it is applied to equipment and focuses on the ability of that equipment to provide its intended function for a specific period of time under stated conditions without failure...
- Ron Moore
- RELIABILITY CONNECT
